
Interlocking ID Tube Clamps
TMR Customs
When TMR Customs was tasked with designing an ID Tube Clamp they went back to the drawing board - the result is the most innovative Tube Clamp on the market! Both bolts can be loaded from the same direction! Gone are the days of threading in one fastener from the front side and one fastener from the backside. Now you can mount TMR Customs tube clamp extremely close to other components on your chassis without interference issues! TMR uses a nylon lock nut. No need to worry about stripping out the tapped holes in your clamps. The nylock nuts key into the machined pocket, eliminating the need to hold them with a wrench or socket when tightening. TMR machines a large 45-degree chamfer along the interlocking edges. This makes it much easier to align the clamps, especially after they have pulled from welding or the tubes have slightly tweaked from a roll over or crash. TMR left enough length on the small ID that is inserted into the tube that you can properly plug weld these for additional strength.
TMR Customs, 877-503-TMR1 (8671), www.tmrcustoms.com